TSSC 186...

Just as I was cleaning up my desk, which is usually a mess after my craft session, I suddenly had an urge to do another card using Black, Red & White.  Why?  Who knows, but create I did.  So to make it a little easier, I went in search of a sketch & as usual Mary-Jo to the rescue.  She always has great sketches!

Mine started off to be a male card, but after looking at the end result, it could either be male or female.  My apologies to Mary-Jo as I didn't strictly keep to the sketch.

Base Card - Riding Hood Red - 5 7/8" x 4 1/4" or 15cm x 10.5cm

Layer 1 - Basic Black - 5 3/4" x 4" or 14.5cm x 10cm

Layer 2 - Very Vanilla - 5 5/8" x 3 7/8" or 14cm x 9.5cm

Layer 3 - DSP - 1 1/2" x 3 7/8" or 4cm x 9.5cm



Card Inside...

 I stamped 3 identical images onto Very Vanilla Cardstock using Basic Black Ink.  I punched 3 circles in Riding Hood Red & layered them over the top of the stamped images.  I adhered the DSP to the bottom of the Very Vanilla & run the whole lot through the Bigshot using Square Lattice Embossing Folder.  This was adhered to Basic Black Cardstock & then to the Base Card - Riding Hood Red.

I stamped 3 smaller identical images onto Very Vanilla Cardstock again in Basic Black, punched them out & adhered on top of the Riding Hood Red circles.

The greeting was inked using Basic Black Ink onto Very Vanilla Cardstock & punched with the Large Oval Punch.  I punched another large oval in Basic Black Cardstock, cut in half & adhered to the back of the Very Vanilla with just a small edge showing top & bottom.  This was adhered over the top of the DSP using SU Dimensionals.

Supplies -

Stamp Set - Circle Circus, Well Scripted

Ink - Basic Black

Cardstock - Very Vanilla, Riding Hood Red, Basic Black

DSP - Love Letter

Punches - 3/4" Circle, 1" Circle, Extra Large Oval

Embossing Folder - Square Lattice

Accessories - Snail Adhesive, Bigshot, SU Dimensionals

Until next time, Enjoy!